Release notes for UBEX
v1.3.2b2
New feature:
-
Fixed issues with using the 10.0.0.0/8 IP range for control
v1.3.1b5
New feature:
-
Added support for No Sync Screen generation on TX/TRX sources (for network diagnostics)
-
Added support for LDC Orientation Preference setting
-
Improved LLDP support (reporting operation mode and package version)
-
Added identify() method to S and O nodes
-
Fixed channel status data for analog audio inputs
-
Refined fan control (silent operation)
-
Added support for R100 part numbers
-
Added support for IR in F110
-
Added support for centralized firmware update
Bugfix:
-
Fixed a glitch with some 10G switches not switching streams atomically
Known issue:
-
Video output is unstable when scaling a precropped image to 4K@60
v1.3.0b10
New feature:
-
Added support for Transceiver mode
-
Added support for scaling to the default resolution of the attached display (EDID-based scaling)
-
Added support for F110 variant (analog audio in/out, RS-232)
-
Added support for upgrading endpoints in matrix mode with LDU2
Bugfix:
-
Signal properties are reported on unconnected outputs as well
-
All RX/TX mode related settings are cleared when operation mode is changed
-
Fixed issues with fan control
-
Added support for LW3 configuration backup and restore
-
Fixed issue with color space conversion for DVI inputs
-
Fixed a glitch with updating dynamic EDID's
-
Improved stability of the embedded bootloader
v1.2.0b1
Bugfix:
-
Fixed issue with detecting HDMI 1.x sources after receiving 4K@60 Hz
-
Fixed 4K@30 Hz transmission over a single 10G link
-
Fixed image artifacts with a few scaling configurations
v1.1.1b1
Bugfix:
-
More robust SCDC handling is introduced.
v1.1.0b6
New feature:
-
Source locked mode is now supported.
-
Scaling and frame rate conversion are also supported on transmitter side.
-
The frame rate converter and scaler modules support image cropping in case of downscaling in center image position.
-
12-bit deep color HDMI signals can be transmitted in 10 bit mode.
Bugfix:
-
4K60 4:4:4 and 4K30 4:4:4 signals can be passed through at the same time.
-
SCDC registers are only modified, if the connected display supports this protocol.
v1.0.1b4
Known issue:
-
4k60 4:4:4 and 4k30 4:4:4 signals can not be passed through at the same time with this version.
-
12-bit deep color HDMI signals can not be transmitted with this version, black image is generated in this case.
-
The configuration restore procedure works on the same type of operation modes only
-
HBR audio formats (Dolby TrueHD; DTS-HD Master Audio 7.1) are not supported
-
4:2:0 sampling is supported on the output ports of the receiver in pass-through mode only
-
The frame rate converter and the scaler do not support image cropping in case of downscaling in center image positon mode. The image will be substituted with white screen.